Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tremron Driveway & Pavers: The Riverside Owner’s Guide
We install and repair Tremron paver driveways and patios throughout Riverside, with typical installed pricing from $7,000 to $18,000 for a full paver driveway, and $3,500 to $11,000 for a paver patio. We keep common Tremron replacement pavers and edge restraints in stock locally, so most repair jobs are scheduled within the week, not the month. Homeowners usually call us after a paver has cracked, the sand joints have washed out, or a section of the driveway has settled into a low spot that holds water after rain. What starts as one broken paver often points to a problem in the base layer or the edge restraint system, and fixing the surface alone means you’ll be back in the same spot next season.
We are an independent Riverside contractor, not affiliated with Tremron, but we work with their pavers every week and know which product lines hold up here and which ones need extra attention in our heat and sun.
Which Tremron Models This Applies To
Tremron’s Florida and Southeast product lines are the ones we see most often in Riverside, specifically the Olde Towne paver, the Vienna paver, and the Tremron coping units used on pool decks and step treads. The key to matching replacement pavers is measuring the depth first. Tremron driveway pavers are typically 60mm thick, while their standard patio pavers and walkway units are 50mm. A paver that looks identical on top will sit wrong in the bed if the depth is off by 10mm, and no amount of sand will level that out. Check the side of a broken paver: most Tremron units carry a faintly embossed mold number or size stamp, and that stamp is the fastest way to identify the series without guessing.
For replacements, you have two options: OEM Tremron pavers ordered through a Tremron-authorized dealer, or quality aftermarket pavers that match the dimensions and color blend closely. With Tremron specifically, the embedded color runs the entire paver rather than a surface-only color coat, which means an OEM replacement ages the same way as the rest of the drive. Aftermarket equivalents work, but the color fade pattern will differ over the Riverside sun exposure, and on a driveway that gets direct afternoon heat from May through October, that difference shows up in about two years.
Styles & brands we work with
Signs Your Tremron Driveway & Pavers Is Failing
- Paver is cracked across the face with a clean break line. This usually means the paver is bridging a void under it, typically from a base layer that lost compaction around a sprinkler head or drain line. The paver isn’t weak; the support beneath it disappeared.
- Sand joints have washed out and gaps are wider than a dime. Rain, runoff, and repeated hosing push the joint sand out. Once the sand is gone, the pavers have no friction lock and they start shifting under every car tire.
- Edge of the driveway is spreading outward, pavers gapping at the curb line. The edge restraint has failed or was never installed correctly. Without a solid edge pin, the whole field can slowly work its way apart under traffic.
- A low spot holds standing water more than an hour after rain. Base material has settled or eroded in that one area. Standing water in Riverside’s dry climate seems harmless, but it accelerates paver freeze-thaw damage on the rare cold morning and softens the bedding layer underneath.
- Individual pavers rock when stepped on or driven over. A rocking paver means the bedding course has broken down beneath it. Over time, that paver will crack at the pivot point, and neighboring pavers follow.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Full paver driveway installation in Riverside runs $7,000 to $18,000, and paver patio installation runs $3,500 to $11,000, depending on square footage, access for excavation equipment, and whether we’re working with an existing concrete slab or building on raw soil. Repairs are priced differently: replacing an isolated section of sunken or cracked pavers typically falls between $800 and $2,500 for a focused repair area. What drives the range is the condition of the base beneath the pavers. If the base is intact and we’re lifting, re-bedding, and resetting the existing field, the job is faster and the number stays low. If we’re excavating bad base, hauling off material, and recompacting from scratch, you’re paying for what you can’t see, and that’s the part that determines whether the driveway lasts eight years or twenty.
Every quote we give is written, itemized, and in your hand before any work starts. That’s the way Curtis Lane runs every Bradford Remodeling job, and it’s the Garrison Standard in writing: the price on the quote is the price on the invoice. Every paver installation carries our 365-Day Done Right Promise. If the field settles, a paver cracks, or an edge pulls loose within a year, we come back and correct it at no charge. Straight number, real scope, no surprises at the final walk.
DIY or Call Us?
There’s a safe middle ground here. You can clearly inspect the joints, look for edge spreading, and mark low spots with a chalk line. You can also sweep fresh polymeric sand into a few joints if they’re just thin, though joint sand in a failed field is a bandage, not a repair. What you shouldn’t do is lift a large section of driveway pavers and recompact the base yourself. The base work requires a plate compactor, proper aggregate, and an honest read on drainage and soil stability. Get the base wrong and the driveway looks good for six months, then fails in the sameplace, only now you’ve spent a weekend and a few hundred dollars in material to do it twice.
If you want us to assess the base and tell you honestly whether the repair is surface-level or structural, call (424) 567-8472. The estimate is free, and you’ll know exactly what you’re dealing with.
FAQs
Properly installed Tremron pavers last 25 to 30 years in Riverside without losing structural integrity, though surface wear and color fade usually become visible after 10 to 15 years of full sun exposure. The base layer has more to do with lifespan than the paver itself: a well-compacted base on stable soil will carry the same pavers decades longer than a thin base over poorly drained ground. Call (424) 567-8472 and we’ll tell you whether your base is the problem.
Yes, a single cracked or chipped Tremron paver can be lifted and replaced in most cases, provided the surrounding pavers and joint sand are in good shape. We keep common Tremron replacement units in stock in our Riverside shop, so the swap is usually same-visit once we’ve matched the series and depth. If neighboring pavers are also shifting, we’ll recommend a section repair instead. Call (424) 567-8472 for an exact quote, free of charge.
Most focused paver repairs in Riverside are completed in one to two days, including lifting the affected area, correcting the base, resetting the pavers, and sweeping in fresh joint sand. Full driveway replacements run longer, typically three to five days depending on square footage and base excavation. We’ll put the finish date in your written quote so you’re not waiting around wondering.
We stock common Tremron replacement units and edge restraints at our Riverside shop, so for most standard series like Olde Towne and Vienna, we don’t need you to order anything. If you have a less common Tremron product or a discontinued colorway, we’ll source it through a Tremron dealer and include the material cost in your quote. Call (424) 567-8472 and we’ll identify your paver series over the phone.
Written by Curtis Lane, Owner, Bradford Remodeling Co Riverside at Bradford Remodeling Co Riverside, serving Riverside and nearby areas.
